BINSFELD ENGINEERING INC.

RT363 Rotary Temperature Transmitter (852-103)

RT363 Rotary Temperature Transmitter (852-103)

The RT363 is a three-channel temperature measurement system designed to monitor temperature on heated godet roll shells. The system features Dienes-compatible output signals for temperature control. Error detection modes protect the heater from damage and expedite troubleshooting in the event of a sensor or other failure. Digital circuitry from sensor input to signal output and generous clearance between the rotating and stationary components make the RT363 a robust and reliable element in the temperature feedback loop.

Installation


 

 

 

 

 

 

 

 

 

 

1. Remove existing transmitter and stator assemblies from motor making note of cable routing.

2. Attach RT363 Stator to mounting ring using supplied #6 x 3/8 screws.

3. Re-route cables and connect the cable from the machine controller to the screw terminals on Stator. See figure 1.

4. Attach the mounting ring and Stator assembly to motor housing using original hardware.

5. Slide RT363 Rotor on to shaft orienting set screw to flat on shaft and re-routing RTD wires through Rotor base.

6. Secure Rotor on shaft with set screw.

7. Attach ring terminals from RTD sensor to rotor screw terminals and tighten securely. See Figure 2.

8. Verify Rotor-Stator spacing (5mm nominal).

9. Complete motor assembly.

Specifications

Error Codes

 

 

 

 

 

 

This document is subject to change without prior notification.

Warranty

Binsfeld Engineering Inc. warrants this product to be free from defects for a period of two years from the date of delivery to the original purchaser and that its products will conform to specifications and standards published by Binsfeld Engineering Inc. Upon evaluation by Binsfeld Engineering Inc., any product found to be defective will be replaced or repaired at the sole discretion of Binsfeld Engineering Inc. Our warranty is limited to the foregoing. Binsfeld Engineering Inc. disclaims any warranty of merchantability or fitness for intended purpose.