RT362 Rotary Temperature Transmitter (852-104)

RT362 Rotary Temperature Transmitter (852-104)

The RT362 is a two-channel temperature measurement system designed to monitor temperature on heated godet roll shells. The system features Dienes-compatible output signals for temperature control on SwissTex (Rieter) machines. Error detection modes protect the heater from damage and expedite troubleshooting in the event of a sensor or other failure. Digital circuitry from sensor input to signal output and generous clearance between the rotating and stationary components make the RT362 a robust and reliable element in the temperature feedback loop.






















1. Remove existing transmitter system from motor.

2. Attach RT362 Stator to motor housing using existing fasteners through mounting holes in stamped plate.

3. Slide RT362 Rotor on to shaft so that the connector mates securely with the RTD connector.

4. Verify Rotor-Stator spacing (5mm nominal).

5. Tighten the two screws in the rotating base securely and evenly (alternate between them frequently).

6. Complete motor assembly.

7. Connect the cable from the machine controller to the 3-pin connector on the Stator.

8. Verify Rotor-Stator spacing (5mm nominal).

9. Complete motor assembly.


Error Codes







This document is subject to change without prior notification.


Binsfeld Engineering Inc. warrants this product to be free from defects for a period of two years from the date of delivery to the original purchaser and that its products will conform to specifications and standards published by Binsfeld Engineering Inc. Upon evaluation by Binsfeld Engineering Inc., any product found to be defective will be replaced or repaired at the sole discretion of Binsfeld Engineering Inc. Our warranty is limited to the foregoing. Binsfeld Engineering Inc. disclaims any warranty of merchantability or fitness for intended purpose.